Filter
Top Products
32
SETUP SETUP SETUPSETUP SetupSETUP
Setting Up the Channel List
After you finish connecting your TV, you need to run Auto Setup to
set up your channels. The Auto Program screens appear when you
turn on your TV for the first time after hooking it up.
Using Auto
Program
To run Auto Program the first time you turn on your TV
1 Press POWER to turn on the TV.
The Initial Setup screen appears.
2 Press V v to move the highlight to the desired language, then
press to select that language.
3 The next screen instructs you to connect your cable/antenna.
Check that you’ve connected your signal source properly.
To start Auto Program, highlight
Yes and then press .
Auto Program automatically creates a list of receivable channels.
When Auto Program is finished, the Tilt Correction screen
appears.
4 Press B b to correct any tilt of the picture. You can choose a
correction between +7 and -7.
When finished, press .
5 The Vertical Correction screen appears. Press V
v to make a vertical correction to the picture. You can choose a
correction between +5 and -5. When finished, press .
When completed, the lowest numbered channel is displayed.
To reset the TV to factory settings
1 Press POWER to turn on the TV.
2 Hold down RESET on the remote control.
3 Press TV POWER on the TV. (The TV will turn itself off, then back
on.)
4 Release RESET.
To exit the Tilt Correction
and Vertical Correction
screens, press the MENU
button.
z
For more details on using
Auto Program, see page 52.
For more details on using Tilt
Correction and Vertical
Correction, see page 59.
z
KV-30/34HS420 Only
HS420.book Page 32 Tuesday, March 30, 2004 10:36 AM