Sony PDW-V1 DVD Recorder User Manual


 
Chapter 2 Names and Functions of Parts
15
2-2 Control Panel
An In or Out point is set when you press the SET button
with the G/IN or g/OUT button held down. The In or Out
point setting is deleted when you press the RESET button
with the G/IN or g/OUT button held down.
c IN indicator and OUT indicator
IN indicator: When an IN point can be set, this flashes,
and when the IN point is set it changes to continuously
lit.
If an attempt is made to set the IN point after a
recorded OUT point, this flashes rapidly.
OUT indicator: When an OUT point can be set, this
flashes, and when the OUT point is set it changes to
continuously lit.
If an attempt is made to set the OUT point before a
recorded IN point, this flashes rapidly.
3 Operating mode selection/menu setting
section
a SUBCLIP button
Press this button, turning it on, to play back following a
clip list (see page 38). This is also valid for jog and shuttle
operations. To play the clips in the order they are recorded,
press this again, turning it off.
The CLIP menu (see page 52) appears in the status display
section and on an external monitor when you press this
button with the SHIFT button held down. Press the MENU
button to escape from the CLIP menu.
Note
If no clip list is registered, this button does not light when
pressed. The operation is invalid.
b THUMBNAIL button
To carry out a thumbnail search or scene selection, press
this button turning it on. Thumbnail images representing
each clip appear. Press once more to turn the button off,
and return to a whole-screen display.
To display the thumbnails of essence mark frames (frames
with an essence mark attached), hold down the SHIFT
button, and press this button. The essence mark selection
menu appears. Select the desired type of essence mark, and
the corresponding essence mark frames appear in
thumbnails. Press once more, turning the button off, to
return to a whole-screen display.
c MENU button
Use for setup menu operations. Pressing this displays the
setting of a setup menu item in the time data display (see
page 74). Press once more to return to the original display.
The system menu (see page 91) appears in the status
display section and on an external monitor when you press
this button with the SHIFT button held down. Press this
button again to escape from the system menu.
d SET button
Use for setup menu settings (see page 75), scene selection
(thumbnail search) settings, and so on.
The scene selection window or a menu for sub clip
operations appears when you press this button with the
SHIFT button held down with either of the following
displayed. The window or menu appears in the status
display section, and on an external monitor.
When a thumbnail screen is displayed: The scene
selection window (see page 46) appears.
When a sub clip thumbnail is displayed: A sub clip
operation menu (see page 48) appears.
e RESET button
Press to reset the counter. This is also used to cancel or
abandon setup menu settings and scene selection
(thumbnail search).
f SHIFT button
Use to switch the functions of various buttons.
4 Playback controls
a PREV (previous) button
Press this, turning it on, to show the first frame of the
current clip. While the first frame of a clip is shown,
pressing this button jumps to the beginning of the previous
clip.
This button is also used together with other buttons for the
following operations.
Reverse direction high-speed search: Hold down the
PLAY button, and press this button. A high-speed
search in the reverse direction is carried out.
SUBCLIP THUMBNAIL
MARK1
MENU
S.SEL
SET
RESET SHIFT
ESSENCE
MARK
CLIP
MENU
SYSTEM
MENU
4 SET button
2 THUMBNAIL button
6 SHIFT button
1 SUBCLIP button
5 RESET button
3 MENU button
TOP F REV F FWD END
PREV NEXTPLAY STOP
1 PREV button
2 PLAY button
3 NEXT button
4 STOP button