Filter
Top Products
Chapter 6 File Operations
63
6-3 FTP File Operations
• Playback, search and other disc operations (see page
15): Stopped
• THUMBNAIL button (see page 15): Off
• Disc access by DELETE, FORMAT, and so on in
the System menu (see page 91): Stopped
• Unsaved current clip list: Save or clear
Note
Login is not possible unless a disc is loaded and the
unit is in the state described above.
2
Start the command prompt.
3
Enter “ftp <SP> <IP address>,” and press the Enter
key. (<SP> refers to a space.)
For example, if the IP address of this unit is set to
“192.168.001.010,” enter “ftp 192.168.1.10.”
Refer to the Windows help for more information about
the FTP command.
If the connection succeeds, you are prompted to enter
a user name.
4
Enter the user name “admin” and press the Enter key.
When the user name is verified, you are prompted to
enter a password.
5
Enter the password and press the Enter key.
The password is set to “pdw-v1” when the unit is
shipped from the factory.
The login is complete when the password is verified.
See 6-3-2 “Command List” (page 64) for the FTP
protocol commands supported by this unit.
If the connection times out
This unit terminates FTP connections if no command
is received within 90 seconds of the last command. If
this occurs, log out (see the next section) and repeat
steps 2 to 4.
Note
If you power this unit off during an FTP connection,
the data transferred thus far is discarded.
To log out
To log out after finishing file operations, enter “QUIT” at
the command prompt and press the Enter key.