Filter
Top Products
Getting started
5
3. Connecting an aerial and a VCR
RF loopthrough
cable (supplied)
Existing
aerial
1. Connect your existing aerial lead to the
Digital socket marked on the rear of the
TV as shown.
2. Connect the supplied RF loopthrough cable
from the socket marked to the analogue
socket marked .
Connecting an aerial and a VCR
1. Connect your existing aerial to the Digital
socket marked on the rear of the TV as
shown.
2. Connect the supplied RF loopthrough cable
from the lower socket marked on the TV
to the RF IN socket on your VCR.
3. Connect a lead from the RF output of your
VCR to the Analogue socket marked on
the TV.
4. Connect a scart lead from the socket marked
on the rear of the TV to the scart
socket of your VCR (refer to VCR instructions).
5. Connect the VCR to the mains socket and
switch on.
6. Insert a pre-recorded tape into the VCR and
press the ‘PLAY’ button. This enables the TV
to locate and store the video channel during
the ‘Automatically tuning the TV’ procedure.
s
3
3
4. Switching on the TV
RF loopthrough
cable (supplied)
Scart lead
(not supplied)
RF lead (not
supplied)
1. Connect the TV plug to your mains socket
(220 - 240 V AC, 50 Hz).
2. Press the on/off switch in a forward direction to
switch on the TV.
Note: If the red indicator on the front of the TV is lit the TV
is in standby mode. Press the TV button on
the remote control to switch on the TV. Please be
patient as the picture may take a few moments to
appear on screen.
/
Connecting an aerial only
NX1-12.fm Page 5 Wednesday, September 5, 2001 9:16 AM