StarTech.com ST121UTPDVEU Cable Box User Manual


 
Instruction Manual
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
Manual Revision: 02/07/2012
For the most up-to-date information, please visit: www.startech.com
Packaging Contents
• 1xDVIExtenderLocalUnit
• 1xDVIExtenderRemoteUnit
• 2xPowerAdapter
• 1xInstructionManual
System Requirements
• DVIenabledvideosourcedevice(i.e.computer,PVR/DVR,etc)
• DVIenabledvideodisplaydevice(i.e.monitor,projector,etc)
• AvailableACelectricaloutatlocal/remotelocations
ST121UTPDVI / ST121UTPDVGB / ST121UTPDVEU
DVI Video Extender over CAT5 UTP
Installation
1.Turnothevideosource(i.e.computer)andtheintendeddisplay
device(i.e.monitor).
2.PositiontheRemoteUnitneartheintendeddisplay.
3.PositiontheLocalUnitnearthevideosource.
Please notethatbothunitswillrequireapowerconnection,so
pleaseensurethateachunitissituatednearanavailablepower
outlet.
4.Connectthevideosourcetothe“DVIIn”portontherearpanelof
theLocalUnit,usingaDVI-Dmale/malecable.
5.Connecttheintendeddisplaytothe“DVIOut”portlocatedonthe
rearpaneloftheRemoteUnitusingaDVI-Dmale/malecable.
6.ConnecttheLocalUnittotheRemoteUnit,usingstandardRJ45
terminatedCAT5cable(seePreparingYourSite).
7.Connectthepoweradapters(provided)tobothLocalandRemote
Units.
8.Turnonthedisplaydevicerst,followedbythevideosource.
Local Unit
Remote Unit
Preparing Your Site
1.Determinewherethelocalvideosource(i.e.computer)willbe
locatedandsetupthedevice.
2.Determinewheretheremotedisplaywillbelocatedandplace/
mountthedisplayappropriately.
3.Ifyouareusingsurfacecabling,ensureyouhaveenoughCat5
unshieldedtwistedpair(UTP)Ethernetcablingtoconnectthe
LocalUnittotheRemoteUnit’slocation,andthateachendis
terminatedwithaRJ45Ethernetconnector.Thecablingshouldnot
gothroughanynetworkingequipment(i.e.router,switch).
OR
Ifyouareusingpremisecabling,ensurethattheCat5unshielded
twistedpair(UTP)EthernetCablingbetweentheLocalUnitand
theRemoteUnithasbeenproperlyterminatedinawalloutletin
eachlocationandthereisapatchcablelongenoughtoconnect
theRemoteUnitandtheLocalUnittotheirrespectiveoutlets.The
cablingshouldnotgothroughanynetworkingequipment(i.e.
router,switch).