Filter
Top Products
2-58
Section 2 — Installation
Connecting to Kaleidoscope
The Kaleidoscope Controller connects to the Model 2200 through an
adapter cable (151022-00) and the Model 2200 RS-422 control cable
(054602-16). See Figure 2-28.
The Model 2200’s Aux Bus video and key outputs (numbered 1 and 2) are
connected to the Kaleidoscope Channel video and key inputs. Note that the
Model 2200’s physical Aux Bus 1 output must be cabled to Kaleidoscope’s
physical Channel A and the Model 2200’s physical Aux Bus 2 to
Kaleidoscope’s physical Channel B.
The Kaleidoscope Channel outputs can be connected to any of the Model
2200 physical inputs (1 to 32), in any order. It is important to note which
physical inputs are connected from which Kaleidoscope Channel outputs,
for both video and key. This information must be entered later into a setup
menu in the Model 2200 (DPM Map Inputs Menu under the External
Interfaces Menu).
When the Kaleidoscope’s outputs are sent to an Output Router, the
Primary Video and Key, and Secondary Video and Key outputs may be
connected to any four inputs on the switcher. The switcher’s inputs are
assigned via menus to any crosspoints (Map Inputs Menu under the Inputs
Menu). This assignment is described later in this section.
Figure 2-28. Model 2200 to Kaleidoscope Cabling
(Port A1) J1
Exp. Comm.
Module
Cell C1
(rear)
Model 2200 Switcher
Frame
Kaleidoscope
Parallel I/O
Module
(068604)
J17 (IPL)
Controller
VIDEO
1
2
3
4
5
Channel (A)
Channel (B)
Channel (C)
Channel (D)
Channel (E)
VIDEO
VIDEO
VIDEO
VIDEO
VIDEO
VIDEO
KEY
VIDEO
KEY
VIDEO
KEY
VIDEO
KEY
KEY
KEY
KEY
KEY
KEY
KEY
Aux Bus
Outputs
(Effects Send Aux Buses
are pairs 1-4 only)
From 1 to 5
Kaleidoscope
Channels
Any Video &
Key Inputs In Any Order
Control Cable
RS-422
(054602-16)
Adapter
Cable
(151022-00)