Filter
Top Products
36
Maintenance
3M™ Digital WallDisplay
©3M 2003. All Rights Reserved.
9. Push down the metal lever on the left side of the lamp cartridge.
10. Reconnect black wires to the receptacle.
11.Close the lamp housing door and tighten the screw.
12. Align the slots and tabs of the right side of the facade and
projection arm as shown, then snap firmly into place.
13. Align the slots and tabs of the left side of the facade and
projection head as shown, then snap firmly into place.
Note: You must hear or feel a distinctive snap to ensure
facade is securely attached.
Whenever the lamp is replaced, please reset the total lamp operating time. (Refer to next page.)
CAUTION
•To reduce the risk of cuts to fingers and/or decreased image quality by
touching the lens, do not insert hand into the empty lamp compartment.
• This lamp contains mercury. Consult your local hazardous waste regulations
and dispose of this lamp properly.
•Apotential hazard may exist in the rare case of lamp rupture. Please have a
3M Digital WallDisplay dealer replace a ruptured lamp.
• The lamp is extremely hot during normal operation. Before replacing the lamp,
wait at least 45 minutes after last operation.
• Do not loosen any screws except those mentioned in the lamp replacement
instructions.