Filter
Top Products
Operating Instruction Book
TU-HDT104A
5
2.2 Rear Panel
• AC Power Mains: (100 - 250V~; 50/60 Hz), 1.0 A.
• RF In: For connection to cable from outdoor terrestrial antenna.
• RF Out: For connection to your TV antenna IN or VCR RF IN.
• S-Video: Y/C component video for connection to TV.
• CVBS: Two composite video outputs for connection to TV, VCR or other A/V
receiver.
• AUDIO: Two sets of stereo audio outputs for connection to TV, VCR or other
A/V receiver.
• YPbPr: Y/Pb/Pr component video for connection to TV.
• RGB: R/G/B/HS/VS component video for connection to TV or monitor.
• Coaxial: Digital Audio output by coaxial.
• Optical: Digital Audio output by optical.
• Serial Port (RS232): For system maintenance.
• A/B/C Switch: Switches for video output mode selection. Selection options are
listed in the table.
2.3 Box Contents
The box that carries your Digital Receiver should also contain the following items:
• Remote Controller
• Two batteries (AAA Size)
• RCA video cables (one white / red, the other red / green / blue)
• User’s Manual
3 The Remote Controller
3.1 Preparing the Remote Controller
• Remove the cover of the battery compartment (on the back of the handset)
• Insert 2 AAA (1.5V) batteries. While inserting, observe the + and – markings
indicated inside the battery compartment.
• Replace the cover
• Test the remote controller by pressing any key and check if the IR-LED (Red)
on the front panel of the receiver flashes.