Toshiba 20A44 Flat Panel Television User Manual


 
9
DIRECT CHANNEL SELECTION buttons (0-9) - Press these
buttons to select a channel. The channel number will appear on
the upper right corner of the TV screen. If an invalid channel
number is selected, the display will revert to the previous
channel.
TV MODE DIRECT CHANNEL SELECTION - When the TV/
CABLE menu option is in
the TV position, all channels can be
instantly selected by using two buttons (For example,
to select
channel 2, press “0,” then “2.” If you press only “2,” channel
selection will be delayed for a few seconds). For channels 10
and above, press the two digits in order.
TV - VHF/UHF channels
CABLE - CABLE TV channels
To turn on the TV, press POWER.
The VOLUME can be adjusted to a desired level by
pressing VOL (VOLUME) + or .
The sound level will be indicated on the TV screen by
GREEN BARS AND A NUMBER. As the sound level
increases, so do the number of BARS AND THE NUMBER
on the screen. The same is true for decreasing the level.
Set the TV/CABLE menu option to the appropriate
position. When shipped from the factory, this menu option
is in the CABLE setting. See
TO MEMORIZE CHAN-
NELS
” on page 8.
TV OPERATION
CABLE mode direct channel selection
When the TV/CABLE menu option is in the CABLE position,
channels can be selected as follows:
1-9
10-12
13-99
100-125
Press “0” twice, then 1-9 as needed.
Example, to select channel 2, press “002.”
Press “0”, then remaining 2 digits.
Example, to select channel 12, press “012.”
Press the 2 digits in order.
Example, to select channel 36, press “36.”
Press the 3 digits in order.
Example, to select channel 120, press
“120.”
1
2
3
4
CH (CHANNEL) + and – buttons
Press and release CH (CHANNEL) + or . The channel
automatically stops at the next channel set into memory.
Press and hold the button down to change channels more
quickly.
For proper operation, before selecting channels, they
should be set into the TV's memory.
See “TO MEMORIZE CHANNELS
” on page 8.
NOTE: If the station being viewed stops broadcasting, the TV
will automatically shut off after 15 minutes.
CLOSED CAPTION
WHAT IS CLOSED CAPTIONING?
This television has the capability to decode and display closed
captioned television programs. When available, closed
captioning will display text on the screen for hearing impaired
viewers or it will translate and display text in another language.
TO VIEW CLOSED CAPTIONS
Press CAP/TEXT on the remote control to switch between nor-
mal TV and the two closed caption modes (Captions and 1/2 of
full screen Text).
Captions: This closed caption mode will display text on the
screen in English or another language (depending on the setting
of Closed Captions 1/2). Generally, closed captions in English
are transmitted on captions channel 1 and closed captions in
other languages are transmitted on captions channel 2.
When activating the closed captioned decoder, there will be a short delay before the closed captioned text appears on the screen.
Closed captioned text is only displayed in locations where it is available.
If no caption signal is received, no captions will appear, but the television will remain in the caption mode.
Misspellings or unusual characters may occasionally appear during closed captioning. This is normal with closed captioning, especially
with live programs. This is because during live programs, captions are also entered live. These transmissions do not allow time for
editing.
When captions are being displayed, on-screen displays, such as volume and mute may not be seen or may interfere with closed
captions.
Some cable systems and copy protection systems may interfere with the closed captioned signal.
If using an indoor antenna or if TV reception is very poor, the closed caption decoder may not appear or may appear with strange
characters or misspelled words. In this case, adjust the antenna for better reception or use an outdoor antenna.
The captions will appear in places on the screen where they
will least interfere with the picture, usually on the bottom of
the screen. News programs will usually show three-line
closed captions which scroll onto the screen. Most other
shows provide two or three lined captions placed near the
character who is speaking so the viewer can follow the
dialogue. Words in italics or underlined describe titles,
words in foreign languages or words requiring emphasis.
Words that are sung usually appear enclosed by musical
notes.
Text: When available, the Text mode will fill part of the
screen with a programming schedule or other information.
After selecting a closed caption mode, it will stay in effect
until it is changed, even if the channel is changed. If the
captions signal is lost due to a commercial or a break in the
signal, the captions will reappear when the signal is
received again. If the channels are changed, the captions
will be delayed approximately 10 seconds.
For television programs broadcasting with closed captions,
look in your TV guide for the closed captions symbol (CC).
3M91301A-E P08-11 13/2/04, 2:069