Filter
Top Products
86
Chapter 8: Using the TV’s features
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Adjusting the audio (continued)
Using the SRS WOW
™
surround sound
feature
WOW
™
is a special combination of SRS Labs audio
technologies (SRS 3D, FOCUS, and TruBass) that creates a
thrilling surround sound experience with deep, rich bass from
stereo sound sources. Your TV’s audio will sound fuller, richer,
and wider.
To adjust the WOW
™
settings:
1. Put the TV in STEREO mode (see “Selecting stereo/SAP
broadcasts” on page 84).
2. Press MENU and open the Audio menu.
3. Highlight Advanced Audio Settings and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
4. Press z or y to highlight the WOW feature you want to
adjust, and then press x or • to adjust the item.
Done
Advanced Audio Settings
WOW: SRS 3D
WOW: FOCUS
WOW: TruBass Low
Reset
Off
Off
• WOW: SRS 3D — To turn the surround sound effect On
or Off.
Note: If the broadcast is monaural, the 3D effect does not
work.
• WOW: Focus — To turn the vocal emphasis effect On or
Off.
• WOW: TruBass — To select the desired bass expansion
level (High, Low, or Off).
5. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
Turning off the built-in speakers
Use this feature to turn off the TV speakers when you connect
an audio system to your TV (see “Connecting a digital audio
system” and “Connecting an analog audio system” on page 20).
To turn off the built-in speakers:
1. Press MENU and open the Audio menu.
2. Highlight Audio Setup and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
3. Press z to highlight the Speakers field, and then press x or
• to select Off.
Done
Audio Setup
MTS
Language
Speakers On
Optical Output Format Dolby Digital
Reset
Stereo
English
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
To turn on the built-in speakers:
Select On in step 3 above.
Selecting the optical audio output
format
Use this feature to select the optical audio output format when
you connect a Dolby Digital decoder or other digital audio
system to the Optical Audio Out terminal on the TV (see
“Connecting a digital audio system” on page 20).
To select the optical audio output format:
1. Press MENU and open the Audio menu.
2. Highlight Audio Setup and press ENTER.
Audio Settings
Advanced Audio Settings
Audio Setup
Audio
3. Press z to highlight the Optical Output Format field, and
then press x or • to select either Dolby Digital or PCM,
depending on your device.
Done
Audio Setup
MTS
Language
Speakers On
Optical Output Format
Dolby Digital
Reset
Stereo
English
4. To save the new settings, highlight Done and press
ENTER. To revert to the factory defaults, highlight Reset
and press ENTER.
______________
• WOW, SRS and
symbol are trademarks of SRS Labs, Inc. WOW technology is
incorporated under license from SRS Labs, Inc.
Downloaded from www.Manualslib.com manuals search engine