Filter
Top Products
38 EN38 EN
3
Use [K / L] to enter the date, then
press [B].
Timer Programming
1/1
MON JAN/01 10:00AM
Date Start End L1/L2
New Program
Date
JAN/02
L1/L2 Mode
SP
SP 2 : 00
Start
- - : - -
End
- - : - -
L1
Daily
MON-SAT
JAN/01
JAN/31
MON-FRI
SAT
FRI
SUN
4
Use [K / L / { / B] or [the Number
buttons] to enter the start and end
time, then press [B].
1/1
New Program
Date
JAN/02
L1/L2 Mode
SP
SP 2 : 00
Start
12 : 00AM
End
- - : - -
L1
5
Use [K / L] to select the appropriate
external input position (L1/L2) to
which your cable/satellite box is
connected, then press [B].
1/1
New Program
Date
JAN/02
L1/L2
L1
Mode
SP
SP 1 : 00
Start
12 : 00AM
End
1 : 00AM
6
Use [K / L] to select a recording mode.
1/1
New Program
Date
JAN/02
L1/L2 Mode
SP
SP 1 : 00
Start
12 : 00AM
End
1 : 00AM
L1
Refer to “Recording Mode” on page 34.
•
You can check the remaining recordable space
of the disc when you select the recording mode.
Date
JAN/02
L1/L2 Mode
SP
SP 1 : 00
Start
12 : 00AM
End
1 : 00AM
L1
Auto recording mode select...
When “Auto” is selected as a recording mode, the unit
calculates how much time is available on the disc and
determines the appropriate recording mode to
complete recording the program.
1/1
New Program
Date
JAN/02
L1/L2 Mode
Auto
Auto 1 : 00
Start
12 : 00AM
End
1 : 00AM
L1
• “Auto” is only available for one program in the timer
program list.
• The recording may be cut short, when the available
recording space of the disc is too limited.
7
Press [ENTER] when all items are
entered.
Your program setting will be stored.
• To set another program, repeat steps 2 to 7.
• To exit, press [TIMER PROG.] or [SETUP].
• When 2 or more programs are overlapped,
“Timer program overlapped” appears, and the
overlapped program will be displayed in blue.
To correct the timer program refer to
“Checking, canceling, or correcting the timer
programming information” on page 39.
8
Press [I/
y
ON/STANDBY] to set a
timer programming.
indicator will appear on the front panel display,
while this unit waits to make the recording.
TIMER RECORDING
When pressing [L] at
the current date, the
date will change as
follows.
e.g.) January 1st