Filter
Top Products
6 F 3 B 0 3 6 4
146
(2) Slave Device Parameter Setting Request
END
START
Remove the cause of the trouble
based on the completion status.
Check the semaphore area use by
referring to "4.5 The Semaphore Area."
Execute the request by referring to "4.6.4
Parameter Setting Request (slave device)."
No
No
Yes
Yes
Is the parameter setting request
completed?
Is the parameter setting request
being executed?
* It takes about 4 seconds per slave device
parameter setting.
Since 10 slave devices can be set at one
parameter setting request, it takes about 40
seconds at maximum.
Go to operation mode control request.