Filter
Top Products
6 F 3 B 0 3 6 4
155
(5) Installation Routes
The following route order is recommended to install transmission cables.
¬ Using the leased route
- Using the computer system leased route
® Using the general instrumentation route
¯ Using the leased route for plant control
8.4.2 Installation Gists Inside the Control Board
Abide by the following points when installing the DeviceNet cable in the Control board.
1) Wiring route
Use the weak signal route in the Control board when wiring DeviceNet cables.
In particular, keep these cables 50 cm away from the power cable.
2) Fixing the Cables
Use clamps to bear the weight of the cable so that the connector doesn't bear it.
Don't bend the cable in circle smaller the minimum bending radius.
3) Ask the manufacturer for the bending radius of the cable and other physical characteristic
values.
4) Don't install cables at a place that has a high temperature, humid environment, dust, or oil mist.