Filter
Top Products
51
CONTENTS
Adjustments &
Settings
FULL MENU settings - Default setting
Return the settings of FULL MENU [Default setting] to the factory default values.
The projector is set to the floor-mounted front projection mode.
The projector is set to the floor-mounted rear projection mode.
The projector is set to the ceiling-mounted front projection mode.
The projector is set to the ceiling-mounted rear projection mode.
The TOSHIBA logo is displayed when no signal is input.
The entire screen is set to blue when no signal is input.
Nothing is displayed when no signal is input.
The power does not turn off automatically even if no signal status continues.
The power turns off automatically when no signal status continues for approx. 5 min.
: COMPUTER IN connector is selectable with the INPUT button.
: Video input is selectable with the INPUT button.
: Use COMPUTER IN connector as Analog RGB input.
: Use COMPUTER IN connector as Y/PB/PR input.
: S-Video input is selectable with the INPUT button.
: Camera input is selectable with the INPUT button.
The power turns on by pressing the ON/STANDBY button.
When the power plug is inserted, the power is on.
The start-up display appears when the power is turned on.
The start-up display does not appear when the power is turned on.
VIDEO SET
Input source setting
SETCOMPUTER
SETAnalog RGB
SETY/PB/PR
S-VIDEO SET
CAMERA SET
Ye s
(common for all of the inputs)
Ye s
(common for all of the inputs)
Ye s
(common for all of the inputs)
Ye s
(common for all of the inputs)
Ye s
(common for all of the inputs)
Ye s
(common for all of the inputs)
Ye s
(common for all of the inputs)
Y/PB/PR
Video
The relationship between input source and item Yes: Adjustable -: Not displayed
S-Video Camera
Analog RGB
Reset
EXEC.
Projection mode Standard SET
Rear SET
Ceiling SET
Rear ceiling SET
Background
Logo SET
Blue SET
None SET
No signal power off
Off SET
5 min. SET
Power on Manual SET
Auto. SET
Start-up screen On SET
Off SET
: On/Off with ENTER
: On/Off with ( ) or ( )
You can set the Input source, projection mode, etc. from FULL MENU [Default setting].
To operate FULL MENU, refer to page
44
.
Notes
• It is impossible to exit from the menu if no input source is selected.
• If the check in the check box for the currently selected source is removed, the setting becomes effective the next time the input is changed.
• In the following conditions, the function to detect no signal (“No signal background”, “No signal power off”) does not activate:
1) When “Video mode”
46
is set to the modes other than [Auto] and Video input or S-Video input is selected.
2) When “Signal format”
46
is set to the modes other than [Auto] and Y/PB/PR input is selected.
• Note that the projector automatically powers up at the restoration of power after a failure, if “Power on” is set to [Auto] with the power plug inserted.
• Even if “Power on” is set to [Auto], the setting of [5 min.] of “No signal power off” is effective.
• Each item can be set at all input sources, but the settings made at one input source are applied in common to all input sources.
• The settings made are memorized automatically when the power is turned off by pressing the ON/STANDBY button. If the power cord is un-plugged or if
a power failure occurs while the projector is on, the settings are not memorized.