Filter
Top Products
(E) 46/52/62HM94
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
92
TV will not turn on • Make sure the power cord is plugged in, and then press POWER.
•The remote control batteries may be dead. Replace the batteries or try the front panel buttons.
•Press the RESET button on the TV front panel (page 9).
• If you have recently replaced the lamp unit, make sure the lamp unit and lamp unit door are installed
properly (pages 98–100).
•The lamp unit may need to be replaced (pages 98–100). Also see “LED indications” on page 94.
Picture problems • Check the antenna/cable connections (Chapter 2).
•Press INPUT on the remote control or TV/VIDEO on the TV front panel and select a valid video input
source (page 67). If no device is connected to any of the inputs on the TV, no picture will display when
you select that particular input source. For device connection details, see Chapter 2.
• Antenna reception may be poor. Use a highly directional outdoor antenna (if applicable).
•The station may have broadcast difficulties. Try another channel.
• Adjust the picture qualities (page 76).
• If you are using a VCR, make sure the TV/VCR button on the remote control is set correctly (page 27).
• If you have two VCRs connected to your TV, do not connect the same VCR to the TV’s output and input
connections at the same time (page 18).
• Do not connect a standard video cable and an S-video cable to VIDEO-1 or VIDEO-2 on the TV back (or
VIDEO-3 on the TV front) at the same time (Chapter 2).
Noisy picture • If you are watching a tuned analog channel (off-air broadcast or Cable TV), set the CableClear DNR
feature to AUTO to reduce visible interference in the TV picture (page 77).
Video Input Selection • If the Input Selection window does not appear when you press INPUT on the remote control or
problems TV/VIDEO on the TV front panel, press INPUT or TV/VIDEO a second time, which will change to the next
video input source and display the Input Selection window.
Cannot view external signals • If you cannot view signals from external devices connected to VIDEO 1, VIDEO 2,
or channel 3 or 4 VIDEO 3, or ColorStream,
®
or from channels 3 or 4, make sure the INPUT LOCK is set to OFF (page 90).
Black box on screen • Set the CLOSED CAPTION feature to OFF (page 78).
Poor color or no color •The station may have broadcast difficulties. Try another channel.
• Adjust the TINT and/or COLOR (page 76).
•When the ColorStream signal source is active, the VIDEO OUT terminal outputs blank video. To receive
video from the VIDEO OUT signal, a standard video or S-video IN jack must be used instead of the
ColorStream connections.
POP problems •The VIDEO OUT jack will not output the POP picture (pages 18 and 74).
Memory card • Make sure you are using a supported or valid memory card format (page 82).
problems
• Make sure you have saved the picture files in the correct file format (page 82).
•The card may be inserted improperly. Remove the card and reinsert it (page 82).
•The memory card may be empty.
•The memory card may be damaged.
Before calling a service technician, please check the following table for a possible cause of the problem and some solutions.
Problem Solution
Troubleshooting
10
HM94(E)092-97(10-Trbl) 8/31/04, 11:43 AM92