Filter
Top Products
40
SET MENU
2 LOW FRQ TEST
TEST TONE • • • • • OFF
OUTPUT • • • MAIN L/R
FRQ • • • • • • • • • 88Hz
Depending on the item, press u/d to select a sub
item.
5 Press j / i repeatedly to change the setting
of the item.
6 Press u/d repeatedly until the current DSP
program appears or simply press one of the
DSP program group button to exit from the
SET MENU.
2 LOW FRQ TEST
TEST TONE • • • • • •ON
OUTPUT • • • MAIN L/R
FRQ • • • • • • • • • 88Hz
1 SPEAKER SET (speaker mode
settings)
Use this feature to select suitable output modes for your
speaker configuration. You must set the output mode
when you use a subwoofer.
Notes
• When 96-kHz sampling digital signals are input to this unit,
level adjustments in items 1B and 1D are possible, but those in
items 1A,1C and 1E are not affected.
• When 6CH INPUT is selected as the input source, level
adjustments in items 1A through 1E are not affected.
■ 1A CENTER SP (center speaker
mode)
By adding a center speaker to your speaker configuration,
the unit can provide good dialog localization for many
listeners and superior synchronization of sound and
images. The OSD shows a large, small or no center
speaker depending on how you set this item.
Choices: LRG (large), SML (small), NONE
Initial setting: LRG
LRG
Select this if you have a large center speaker. The entire
range of the center channel signal is directed to the center
speaker.
SML
Select this if you have a small center speaker. The low-
frequency signals (90 Hz and below) of the center channel
are directed to the speakers selected with “1D LFE/BASS
OUT”.
1A CENTER SP
LRG
SML
NONE
1A CENTER SP
LRG
SML
NONE
or
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the settings of the SET MENU you
adjusted will return to the factory settings. If so, adjust
the items again.