ok found a code for the TV Vision but not right model as have Vision VS40LEDP but u not have listed. Ok so went to do the LERNING REMOTE and so closed software. reopen software and configured to digitech remote. Ok then hit the LEARN KEY and on of but stays steady so it learnt each key from tv remote. Ok all successful. turn off the learn fuction and had to wait and disconnect and press any buttone.. ok will not work the TV no matter what u do.. so hooked up again as in instructions and pushed the learn on again... nothing says all learnt. what can be the problem here. the Digitech was configured to preset listing in search for model. do I need to clear that out first if so how to factory reset. plus why will it not work the TV once it learnt from the TV REMOTE ???!!!!