My Haier HL37E HDTV is stuck in standby mode and will not turn on. Is there a solution or a workaround for this issue? I found that there are a LOT of people with this same issue.

Asked by Donavan Guhl on 10/14/2008 4  Answers

ManualsOnline posted an answer 16 years, 1 month ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here
3 If the issue is still unresolved after following all of the troubleshooting steps, service may be required. Please note the number of times the STANDBY light flashes and relay that information to the service center.
Was this answer helpful?
3 My tv comes on but it stays on the blue screen and says no signal. Im also unable to do anything with it its like its froze on the start up screen
Was this answer helpful?
0 The STANDBY light will flash if the television detects an issue within the television. Some of these issues can be resolved simply by following the steps below to reset the television. 1. Turn off the television. IMPORTANT: For a projection television that uses an internal lamp, wait 5 minutes after turning off the television to allow the lamp to cool before continuing with the following steps. 2. Unplug the television power cord from the electrical outlet. 3.Let the television remain without power for 60 seconds. 4. Plug the power cord back into the electrical outlet. NOTE: If the television is plugged into a power strip or surge protector, remove it from the power strip or surge protector and plug it directly into the wall outlet. If the issue is resolved, the problem is with the power strip or surge protector and not the television. 5.Turn on the television.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.