9
Raise the latch on the remote control’s back cover to remove. Insert two batteries carefully noting
the “+” and “–” markings, placing the “–” end in the unit first. Snap the cover back into place.
Getting Started
Step One - The Remote Control (Optional)
The remote control is the key to operating your television's many great features. Before you can
operate your remote control, you first need to install the batteries.
Basic Operation
Turn the television on and off by pressing the POWER button at the top right corner of the remote.
The four key feature buttons at the center of the remote can be used for basic operation of the
television.The top and bottom buttons will scan forward and back through the available channels.
The right and left buttons will turn the volume up or down. These buttons are also marked with four
arrows and are also used with JVC's onscreen menu system.You will need to use these buttons
later in the Quick Setup Section.
The next step is to connect your television to an antenna or cable.
POWER
MUTING
MENU
V CHIP
+
CH
VOL
VOL
+
CH
EXIT
Remote Power
Button
Remote Key Feature Buttons
☞
Proceed to Step Two
These quick setup pages will provide you, in three easy steps, with the basic information you need
to begin using your new television right away. This information includes basic instructions on
operating your optional JVC remote control, making a simple cable/antenna and optional VCR
connection.
If you have questions, or for more detailed information on any of these steps, please consult other
sections of this guide.
Quick Setup 1
Hotel IB 6/28/2001 10:13 AM Page 9
