Filter
Top Products
4 78-0013-1746-6-E
1.3 Additional materials needed:
• De-ionized or distilled water for nano-finishing at
above-freezing temperatures
• 25% to 35% methanol by volume and 75% to
65% de-ionized or distilled water solution by
volume for nano-finishing at below-freezing
temperatures. DO NOT use ethanol or isopropyl
alcohol for nano-finishing.
• 99% pure isopropyl alcohol (for cleaning only) or
a fiber optic connector cleaning solution approved
by your company.
Note: Carefully follow safety, health and environmental
information given on product labels or the Material
Safety Data Sheets for isopropyl alcohol, fiber optic
cleaning fluid, and/or methanol/water solution.
1.4 Optional accessory:
3M
™
200X View Scope 6365-VS. DO NOT use when
connectors are illuminated by a laser source.
2.0 Connector and Protrusion Setting Tool Preparation
2.1 On the 3M
™
Protrusion Setting Tool, move the
actuator lever to the unactivated position as shown.
2.2 Clean the tip of the protrusion setting jig using a lint-free cleaning swab with a drop of alcohol or cleaning fluid.
Reach through the window with the swab and move the swap tip vertically to clean the jig tip.
wipe jig tip with vertical motion