Filter
Top Products
14 78-0013-1746-6-E
5.2 Wet the top surface of the finishing disc with 2 squirts
of de-ionized water using the spray bottle provided.
Avoid using excessive amounts of water. Close the lid
fully and ensure the latch is engaged.
Note: Wetting the disc surface is important because it
carries off glass particles that have been removed. Failure
to wet the disc results in poor connector performance.
5.3 Insert the connector into the port on the 3M
™
Nano-finisher lid making certain it is fully engaged. Push until a click
is heard.
Push down
further
Push down
until it clicks
5.4 Press the release button on the side of the finisher.
The button will stay depressed until the finishing
sequence is complete. It pops back up automatically.
Allow this to happen by keeping clear of the button
during the sequence.
5.5 Rotate the input knob one full turn with a single
continuous motion. The finisher automatically stops
the input knob after one full turn.
5.6 Remove the connector from the port on the
finisher lid.
Note: The nano-finisher is best stored dry – inside and out.
Open the lid as shown in step 5.1, and allow to dry.