Filter
Top Products
978-0013-1746-6-E
3.14 Rotate the fiber so the fiber curl is directed
downward in the fiber holder.
3.15 Hold fiber at rear, and pull the fiber backward.
Position the fiber so the tip is flush (±1 mm) with the
end of the nozzle.
Note: The 900 µm coating edge can be seen through a
hole in the shuttle. Viewing this is a good method
to check that the cleave length is correct (24 mm).
For 250 µm, the edge cannot be seen through the
hole, since it has a 19 mm cleave length.
Fiber tip fl ush
with nozzle
900 µm Coating
edge visible in hole
3.16 Close and latch the buffer clamp.