Filter
Top Products
DV89
6
DV89
7
Conguring your DVD player
Introduction
Congratulations – if you have followed the installation
instructions then the required connections to other equipment
will have been made. It is now essential to go through an
initial set up procedure to ensure the DVD player is congured
correctly for use.
Switching the power on
Press in the POWER button on the front panel. The power LED
above the switch lights green.
Obtaining a TV picture
Ensure the TV is switched on and that you have selected the
correct TV input. You should see the following image. This is
the image that the DVD player gives whenever there is no disc
playing.
To protect your screen from damage caused by persistent
static images, a ‘screen saver’ facility activates after a few
minutes of inactivity. (To stop the screen saver, press STOP on
the front panel or remote control.)
Using the Set-up menus
If you have not already done so, now would be a good time to
t the two AAA batteries in the remote handset, taking care
to get them the correct way round. Select ‘DVD’ using the
CD/DVD button on the remote control.
Ensure that no disc is playing and press SETUP on the remote
control: a menu appears on the TV screen.
The Set-up menu comprises seven pages of options. The top
line of each page shows the page title, indicating the nature of
the settings controlled by the page. To make a change, rst
use the UP/DOWN controls to highlight the item. Once the item
to be changed has been highlighted, press RIGHT to open the
list of options for the menu item. The current option for the
menu item is shown highlighted; the UP/DOWN controls can be
used to select the new option, then pressing LEFT conrms the
selection and closes the option list.
To change page, highlight the page bar at the top of the
screen and use the LEFT/RIGHT controls to move through the
pages.
In the ‘Setup’ menu, the UP/DOWN controls ‘wrap around’,
so that with the highlight bar at the bottom of the screen,
pressing DOWN takes the bar to the top of the screen.
Operational setup
Operation 1/ 7
OSD Language
DVD Menu
English
CR-314
On
Remote type
Subtitle
Audio
OSD Status
English
English
English
DVD VideoPriority
OSD Language
This setting controls the language of the messages displayed
on the On-Screen Display (OSD). The default language is
English, with three other languages supported.
Note that this setting does not change the language of any
information displayed on the front panel, which is always in
English.
DVD menu
Some DVD discs support a number of different languages
for the DVD disc menu (the menu present on the DVD itself).
This setting allows the preferred language to be specied. For
example, if this item is set to ‘French’ then disc menus will be
displayed in French, where supported by the disc.
Note that not all discs will have your preferred language
available.
Subtitle
This setting controls the subtitles displayed on the TV.
Off No Subtitles
Auto Subtitles for the primary language on the
disc
Closed Caption ‘Closed Caption’ information from the disc (if
present) is sent to the TV
English English subtitles
French French subtitles, etc. (six languages are
supported)
Note that some discs may force the subtitles to be displayed
regardless of how the Subtitle item is set.
Closed Caption information is displayed only if the ‘Closed
Caption’ option is selected, closed caption information is
present on the disc, and your TV supports closed caption
decoding.
The default setting for Subtitle is ‘Off’. Alternatively, choose the
setting for the language you prefer. Note that not all discs will
have your preferred language available as a subtitle.
Audio
This controls the default audio track, when there is more than
one audio track present.
English English language, if available
French French language, if available, etc. (six languages
are supported)
The default setting is ‘English’. Choose the setting you would
like as default. Note that the Audio preference setting is not
respected by all discs, which may impose their own default
choice.