Filter
Top Products
English - 51 -
Connect the PC cable between the PC INPUT on the TV and the PC output on your PC.
Note: You can use YPbPr to VGA cable (not supplied) to enable YPbPr signal via VGA input.
WARNING: You cannot use VGA and YPbPr at the same time.
SPDIF Out5. outputs audio signals of the currently watched source.
Use an SPDIF cable to trasfer audio signals to a device that has SPDIF input.
DC 12 V Input 6. is used for connecting the supplied power adaptor.
V+
V+
V-
V-
.
Viewing the Connections - Side Connectors
The CI Slot is used for inserting a CI card. A CI card allows you to view all the 1.
channels that you subscribe to. For more information, see “Conditional Access”
section.
Side USB input.2.
Side audio-video connection input is used for connecting video and audio signals 3.
of external devices. To make a video connection, you must use the supplied AV
connection cable for enabling connection. First, plug singular jack of the cable to the
TV’s Side AV socket. Afterwards, insert your video cable’s (not supplied) connector
into the YELLOW input (located on the plural side) of the supplied AV connection
cable. Colours of the connected jacks should match.
To enable audio connection, you must use RED and WHITE inputs of the side AV
connection cable. Afterwards, insert your device’s audio cable’s connectors into
the RED and WHITE jack of the supplied side AV connection cable. Colours of the
connected jacks should match.
Note: You should use audio inputs of side AV connection cable (RED & WHITE)
to enable sound connection when connecting a device to your TV by using PC or
COMPONENT VIDEO input.
The headphone jack is used for connecting an external headphone to the system. 4.
Connect to the HEADPHONE jack to listen to the TV from headphones.
Volume/ Programme/ Source and Standby-On switch5.
Power Connection
IMPORTANT: The TV set is designed to operate on 12 V DC. For this, an adaptor is used which gives
12 V voltage. Connect this adaptor to a system that supplies 110-240V AC,50/60Hz.
After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the •
mains .
To POWER
INPUT DC 12 V
terminal
AC adapter
H
M
D
I
1
SPDIF
Coax.OUT
12V
DC IN
MODE
o
A02_MB62_[GB]_(01_TV)_woypbpr_IDTV_BRONZE19_1900UK_24912WLED_10075162_50199152.indd 51A02_MB62_[GB]_(01_TV)_woypbpr_IDTV_BRONZE19_1900UK_24912WLED_10075162_50199152.indd 51 22.08.2011 15:50:3522.08.2011 15:50:35