Filter
Top Products
FRONT PANEL CONTROL (see figure 3)
NT PANEL CONTROL
• Standby Switch: When pressed, the monitor enters the off mode, and the LED
turns orange. Press again and hold to restore normal status.
• Power Indicator :
Green — Power On mode.
Orange — Off mode.
• Shuttle Knob : The Shuttle Knob is used to control the monitor functions. Rotate
to switch functions or adjust settings. Press to select or execute a function.
HOW TO ADJUST A SETTING
1. Press the Shuttle Knob or OSD Key to make the OSD window appear. See figure 4.
2. Rotate the Shuttle Knob to select the desired function.
See figure 4.
3. Press the Shuttle Knob again to select the function that you want to adjust.
4. Rotate the Shuttle Knob to change the settings of the current function.
5. When the OSD window is active, it shows the input signal timing. The "H" stands
for the horizontal frequency and "V" for the vertical frequency.
6. To exit and save, either press the OSD Key, select the exit function, or leave the
monitor alone for 10 seconds.
If you want to adjust any other function, repeat steps 2-4.