Filter
Top Products
08/2004
WRS
System Guide
07
What About the Wired Lens Control System?
Most parts of the wired Lens Control System can still be used with some minor limitati-
ons. Below is a short run down of compatibilities. Details can be found in the Lens
Control System manual.
The Zoom Main Unit (ZMU-1 or ZMU-2) can be connected with a cable to the UMC-1,
Studio LDB, Studio LDB-2, Lite LDB, Lite LDB-2 or FEM-2 to control zoom. It is also
possible to connect the Zoom Main Unit directly to the CLM-1 motors, which in turn
must be connected to a UMC-1, LDB, LDB-2, FEM-2 or external power supply. Having
multiple zoom controllers connected (like a ZMU and a WZU, for instance) is not a pro-
blem, even though one of them will be the master and the other one will not function.
One or two Focus Iris Units (FIU-1) can be connected to a ZMU-1 or ZMU-2. From
ARRICAM Software packet 03E on this configuration will also work with the ARRI-
CAM system. When using the FIU-1 with the ARRICAM system, it is recommended to
not use a Wireless Main Unit or WHA-2 at the same time.
Additional Literature
Wireless Remote System Brochure Ident. No. K5.58511.0 (English)
Lens Control System Instruction Manual Ident. No. K5.52423.0 (English)
Lens Control System Bedienanleitung Ident. No. K5.52422.0 (German)
Wireless Remote Control (WRC-1) Instruction Manual Ident. No. K5.43668.0 (English)
Wireless Remote Control (WRC-1) Bedienungsanleitung Ident. No. K5.43660.0 (German)