Asus VN247HP Flat Panel Television User Manual


 
3-7
ASUS LCD Monitor VN247 Series
3.3 Troubleshooting (FAQ)
Problem Possible Solution
Power LED is not ON
Press the button to check if the monitor is in the
ON mode.
Check if the power cord is properly connected to
the monitor and the power outlet.
The power LED lights amber and
there is no screen image
Check if the monitor and the computer are in the
ON mode.
Make sure the signal cable is properly connected
the monitor and the computer.
Inspect the signal cable and make sure none of the
pins are bent.
Connect the computer with another available
monitor to check if the computer is properly
working.
Screen image is too light or dark Adjust the Contrast and Brightness settings via
OSD.
Screen image is not centered or
sized properly
Press the button for two seconds to
automatically adjust the image.
Adjust the H-Position or V-Position settings via
OSD.
Screen image bounces or a wave
pattern is present in the image
Make sure the signal cable is properly connected to
the monitor and the computer.
Move electrical devices that may cause electrical
interference.
Screen image has color defects
(white does not look white)
Inspect the signal cable and make sure that none of
the pins are bent.
Perform Reset via OSD.
Adjust the R/G/B color settings or select the Color
Temperature via OSD.
Screen image is blurry or fuzzy
Press the button for two seconds to
automatically adjust the image (for VGA mode
only).
Adjust the Phase and Clock settings via OSD.
No sound or sond is low (only for
VN247H)
Make sure the audio cable is properly connected to
the monitor.
Adjust the volume settings of both your monitor and
computer.
Make sure the computer sound card driver is
properly installed and activated.