Filter
Top Products
- 8 -
DIP Switch Configuration
The IC-485AI’s settings for Baud Rate, Data Format, and RS-422
/ RS-485 Mode are configured by setting the eight segment DIP
Switch located on its bottom panel
Note: When you change any of the DIP Switch settings, you
must reset the device by powering it off, then powering
it on again.
SW 1-3: Baud Rate
Note: 1. The Baud Rate must be the same for all units on the
installation.
2. The default is 9600 bps.
SW 4: Reserved
Baud Rate SW1 SW2 SW3
1200 ON ON ON
2400 OFF ON ON
4800 ON OFF ON
9600 OFF OFF ON
19200 ON ON OFF
38400 OFF ON OFF
57600 ON OFF OFF
115200 OFF OFF OFF