Filter
Top Products
ENGLISH
24
4 RESET Press this button for 10 seconds to
restore factory default setting.
1.4 Default Settings
Before you configure the NetServer Pro, you need to know the following
default settings:
Password:
Username:
IP address : 192.168.0.1
1.5 Cabling
Follow these steps for a trouble-free start of the print server operations
with your print server.
1. Confirm proper operation of the printer to be connected to the print
server.
2. When you have confirmed proper operation of the printer, turn off its
power.
3. Confirm that your network is operating normally.
4. Connect the print server to the network (through the RJ-45 connector
of the print server or IEEE 802.11g wireless interface).
Configuration problems may result if the print server is
powered up without first establishing its network
connection. Please follow this procedure to avoid
complications at the configuration stage.
5. While the printer is powered off, plug the print server to the printer
(USB interface).
6. Turn on the printer’s power.