Filter
Top Products
Toll free: 1-877-536-3976
Local: 1-408-962-0515
7
atlona.com
1. Place your switcher within 60 feet (18.29 meters) of your video display.
Note: If using the supplied IR remote control, remember you need to be within 23 feet (7
meters) and within a 60° angle of the infrared receiver.
2. Connect the HDMI cables to your sources and the switcher’s inputs labeled HDMI IN.
Note: The Ethernet Channel will not pass to your devices if the HEC feature is not supported
or you are not using the correct HDMI cables.
3. (Optional) Plug the supplied Infrared module into the IR IN port and place the receiver end
somewhere that is within 23 feet (7 meters) of where you will be using remote.
Note: The supplied infrared module will allow you to control the Atlona AT-HD4-V41 when
placed in a cabinet.
4. Plug the power cord into the DC 5V labeled port and then plug the other end into the wall.
5. (Optional) Plug the Ethernet cable into the Ethernet port. If your devices and cables are
HDMI Ethernet Channel compatible you will be able to pass the internet signal through the
HDMI cable.
Note: Please verify that your devices are HDMI Ethernet Channel compatible, most ports will
be labeled HEC for easy identification.
6. (Optional) Plug the Digital (S/PDIF) cable into the S/PDIF port. If you have an audio system
this will allow for 2 channel and multi-channel support.
Note: If the Digital Audio is plugged in it will take first priority over the HDMI audio
connection. Neither Dolby TrueHD or DTS-HD Master Audio will work with this option.
a. (Optional) ARC Mode – The Audio Return Channel can be accessed through the
switcher, by reselecting the source you currently have selected (all source lights will
go off). The switcher will then pass through the audio from your video display to
your A/V Receiver as an ARC signal (this will only work with ARC capable displays).
Your video display will pass through audio from either its internal tuner or from any
device plugged into it.
7. Connect one end of the HDMI cable into the video display and the other end into the port
labeled HDMI OUT on the switcher.
8. Press the power button (on either the remote or the switcher) to turn on the
AT-HD4-V41.
9. (Optional) If using the RS-232 connection plug the cable into the switcher, then your
computer or third party control.
Note: You can purchase the RS-232 cable at: http://www.atlona.com/
a. PC control will need a hyperterminal program. If you do not have one then you will
need to download or purchase one and follow their instructions for the program’s
installation.
Step by Step Guide