Audiovox VE 927 TV DVD Combo User Manual


 
- 29 -
SYMPTOM CAUSE (AND REMEDY)
The region number of the disc doesn't match the region number of this unit.
Clean the disc.
The disc is scratched.
The picture is not
clear
No picture
Make sure that you've selected DVD mode.
The system is in pause mode. Press the PLAY button to return to normal play
mode.
Fast forward or fast reverse is performed. Press the PLAY button to return to
normal play mode.
The DTS DVD cannot be decoded to have speaker output.
This unit is too hot. Shut off the unit for 30 minutes to allow it to cool down.
The remote does
not function.
Ensure the AC power cord is connected.
The unit is not turned on.
No power.
DVD
No sound or only a
very low-level
sound is heard.
Clean the disc.
There is no disc inside ("No Disc" appears on the screen).
Insert the disc correctly with the label side facing up on the disc tray.
Clean the disc.
A non-NTSC disc has been inserted. The unit and disc region number are incom-
patible.
Condensation may have formed inside the unit due to a sudden change in tem-
perature. Wait about an hour for it to clear and try again.
The disc does not
play.
Severe hum or
noise is heard.
Remove any obstacles between the remote and the unit.
Use the remote near the unit.
Point the remote at the remote sensor on the unit.
Replace all batteries in the remote with new ones.
TROUBLESHOOTING GUIDE
TV
Snowy picture,
multiple image,
picture distorted,
picture blurred and
noisy sound.
Check antenna location, direction or connection.
Check the PICTURE SETTING in the TV SETUP MENU.
Not plugged into AC outlet.
Make sure that you've selected TV mode.
Try a new channel to check for possible station trouble.
Make sure the antenna is connected to properly.
Increase the volume.
The antenna is broken.
Check for local interference.
No color of picture.
No picture and
sound.
Magnetic interference from unshielded equipment.
Turn OFF the unit for 30 minutes, then turn ON again.
Colored patches of
picture.