Audiovox FPE1508 Flat Panel Television User Manual


 
E - 17
MAINTENANCE
CLEANING THE UNIT
Be sure to turn the unit off and disconnect the AC power cord before cleaning the unit.
Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that has been
dipped in a weak soap-and-water solution and wrung out thoroughly. Then wipe it with a dry cloth.
Never use alcohol, benzene, paint-thinner, cleaning uid or other chemicals. Do NOT use compressed
air to remove dust.
TROUBLESHOOTING GUIDE
SYMPTOM CAUSE (AND REMEDY)
The remote does not
function.
• Make sure the AC power cord is connected.
The unit is not turned on.
No power.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
Point the remote at the remote sensor on the unit.
Replace the batteries in the remote with new ones.
• Check the location of the antenna and adjust it if necessary.
Make sure the antenna cable is rmly connected.
Make sure all input cables are rmly connected.
TV
Bad Picture (snow,
multipe images,
distortion, blurry)
Check the PICTURE MENU within the TV SETUP MENU.
Check to make sure the program you are watching is broadcast in Color and
not black and white.
Black and white
picture.
• Make sure the unit is plugged in and turned on.
Make sure TV mode is selected.
Try a new channel to check for possible station trouble.
Make sure the antenna is connected properly.
Increase the volume.
Make sure the antenna or audio video source device is working properly.
Make sure all cables are rmly connected.
Check for local interference.
No picture or sound.
Make sure there are no unshielded electrical devices nearby that are causing
interference.
Turn the unit off for 30 minutes, then try it again.
Colored patches of
picture.
16159S2_UL_ENGLISH IB.indd 17 1/9/2008 2:13:38 PM