Filter
Top Products
E - 13
INSTALLATION
REMOVING THE BASE STAND
WARNING: The LCD display is very fragile, and must be protected at all times when removing the base
stand. Be sure that no hard or sharp objects, or anything that could scratch or damage the LCD display,
come in contact with it. Do NOT place pressure on the rear of the unit at anytime because the screen
could crack.
MOUNTING ON THE WALL
This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 7 7/8” x 3 7/8”
(200mm x 100mm) mounting kit designed for flat-panel TVs (sold separately). Mount this unit according
to the directions included with the mounting kit.
NOTE
Remove the base stand before mounting the unit on the wall.
1.Disconnect any cables or
cords connected to the unit.
2. Lay the unit down on a flat
surface, so the back side is
facing up, making sure to
place a soft cushioned
material (such as a blanket
or thick piece of foam)
beneath the screen.
3. Remove the 8 screws and
then remove the BASE
STAND from the unit.
7 7/8”
3 7/8”
Six mounting
holes
PLV36260_ib_eng_1-13_AUD.pmd 9/13/2007, 3:24 PM13