Audiovox FPE2608DV Flat Panel Television User Manual


 
E - 12
CONNECTIONS
CONNECTING A HIGH-DEFINITION (HD) SOURCE
High-Definition (HD) Devices with component video output must be connected to the YUV input.
Connect the component video cable and audio cable (not included) as shown.
Make sure you connect the component video cable and audio cable from the other equipment
(COMPONENT VIDEO OUT and AUDIO OUT) to this unit (COMPONENT VIDEO IN and AUDIO IN - YUV
IN).
NOTE
When connecting a DVD player to the television, the picture resolution is solely dependent upon the
resolution supported by the DVD player attached. DVD player resolutions vary from 480i to 1080i, and
this unit can support DVD players up to a maximum resolution of 1080i.
To AUDIO
IN jacks
(YUV IN)
To AUDIO
OUT jacks
To
COMPONENT
VIDEO IN jacks
(YUV IN)
To COMPONENT
VIDEO OUT jacks
* May require a subscription
for receiving HD
channels. Check with
your cable/satellite service
provider for details.
CONNECTING A PC
Connect the 15-pin D-SUB PC/VGA connector from your computer to the 15-pin D-SUB PC/VGA input on
this unit using a monitor cable and audio cable (not included) as shown.
Make sure you connect the
cable from the computer (PC
Connector and PC AUDIO) to
this unit (PC IN MONITOR / VGA
and AUDIO).
To PC AUDIO OUT jack
To PC connector
FPE2608DV_ib_eng_1-16.pmd 1/15/2008, 12:42 PM12