Filter
Top Products
128-6317
C. Installation
1) Choose an appropriate mounting location underneath a cabinet or shelf. Close
proximity to an electrical outlet and a TV antenna or cable connection will
facilitate a neat, easy installation. Do not mount the VE-560 above a range
or oven. Be sure that the location chosen will provide adequate access to
the electrical connectors on the rear of the unit before continuing.
2) If the location chosen has bottom edge molding it may be necessary to use
the mounting spacers provided to effectively lower the VE-560’s front panel
below the molding. Measure the distance between the bottom of the mold-
ing and the bottom of the cabinet. A maximum measurement of 1.5” can be
accommodated without using spacers. For larger moldings choose a com-
bination of spacers which will reduce the mounting depth to 1.5” or less.
3) Measure the thickness of the bottom of the cabinet or shelf and the spacers
chosen. Select the shortest screw length which will pass through the coun-
tersunk washer, kitchen cabinet and spacers with between 1/4” and 1 1/2”
inches to spare
4) Cut out the template supplied and tape it in place onto the cabinet surface to
be drilled. Center punch the four holes indicated on the template and re-
move the template.
5) Carefully drill four 1/4” holes at the locations marked above. Place the screws
chosen through the countersunk washers and then through the holes from
the top down.
6) Screw the appropriate spacers on to the screws first, then position the VE-
560 and screw it in place using its threaded holes.
7) Plug the AC Power adapter into a nearby electrical outlet and into the recep-
tacle marked DC 12V input at the rear of the VE-560
8) Connect your TV antenna or cable system to the antenna connector on the
rear of the VE-560.
9) Route the wires safely away from heat and moisture sources and secure
them in place using the self adhesive wire mounting clip provided.
2
UNDER CABINET INSTALLATION
Cabinet or Shelf
Bottom Edge Molding