Filter
Top Products
4
plug. If the plug still cannot be inserted, contact your electrician to replace your outlet. Do not defeat
the safety purpose of the polarized plug.
13. Power-Cord Protection – Power-supply cords should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them paying particular attention to cords at
plugs, convenience receptacles, and the point where they exit from the product.
14. Outdoor Antenna Grounding – If an outside antenna or cable system is connected to the product,
be sure the antenna or cable system is grounded in order to provide some protection against voltage
surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provide
information with regard to proper grounding of the mast and supporting structure, grounding of the
lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna-
discharges unit, connection to grounding electrode (Refer to the figure on page 6).
15. Lightning – For added protection of this product during a lightning storm, or when it is left
unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the
antenna or cable system. This will prevent damage to the product due to lightning and power-line
surges.
16. Power Lines – An outside antenna system should not be located in the vicinity of overhead power
lines or other electric light or power circuit, or where it can fall into such power lines or circuits.
When installing on outside antenna system, extreme care should be taken to keep from touching
such power lines or circuits as contact with them might be fatal.
17. Overloading – Do not overload wall outlets, extension cords, or integral convenience receptacles, as
this can result in a risk of fire or electric shock.
18. Object and Liquid Entry – Never push objects of any kind into this product through openings in the
chassis as they may touch dangerous voltages points or short-out parts that could result in a fire or
electric shock. Never spill liquid of any kind on the product.
19. Servicing – Do not attempt to service this product yourself as opening or removing covers my
expose you to dangerous voltages or other hazards. Refer servicing to qualified service personnel.
20. Damage Requiring Service – Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions.
A. When the power-supply cord or plug is damaged.
B. If liquid has been spilled, or an object has fallen into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating instructions, as an improper adjustment of
other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to it’s normal operation.
E. If the product has been dropped or damaged in any way.
F. When the product exhibits a significant change in performance – this indicates a need or
service.