Filter
Top Products
UNDER CABINET INSTALLATION
1) Choose an appropriate mounting location underneath a cabinet or shelf. Close proximity to an electrical
outlet, TV antenna or cable connection will facilitate a neat, easy installation. Do not mount the VE726
above a range or oven. Be sure that the location chosen will provide adequate access to the electrical
connections on the rear of the unit before continuing.
2) If the location chosen has a bottom edge molding it may be necessary to use the mounting spacers
provided to effectively lower the VE726 below or even with the molding. Measure the distance between
the edge molding and the bottom of the cabinet. The spacers and mounting holes are stepped to
achieve different mounting heights from .5” to 1”. Adjusting the mounting height is done by lifting and
rotating the spacer in the mounting hole. Choose a spacer height, which will allow the VE726 to clear
the edge molding.
3) Measure the thickness of the bottom of the cabinet or shelf and the spacer height chosen. Select the
shortest screw length, which will secure the VE726 to the bottom of the cabinet.
4) Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center punch
the four holes indicated on the template and remove the template.
5) Carefully drill four 1/8″ holes at the locations marked above.
6) Connect your TV antenna or cable system to the antenna connector on the rear of the VE726.
7) Attach the FM Dipole Antenna and position the antenna for the best reception.
8) Attach the AM Antenna and position the antenna for the best reception.
9) Position the VE726 and mount it in place using the selected screws.
NOTE: Do not over-tighten.
10) Plug the AC power cable into the wall outlet. Route the wires safely away from heat and moisture
sources.
8