Filter
Top Products
www.avenview.com
8
1.7.3 HDMI-C5XD-SR Rear Panel
1 2 3 4 5 6 7
1. Input Signal format indicator
(Bright: HDMI Single, Dim: DVI Signal)
2. Rotary Switch
3. RJ45 IN: Connect RJ45 Source from
HDMI-C5XD-S
4. Audio Out: Plug in Local Speaker
5. HDMI OUT: HDMI Local Output
6. HDMI Signal Out: RJ45 connection to
connect to HDMI-C5XD-SR or
HDMI-C5-3-R
7. Power Connector: 5V 4A DC
1.7.4 HDMI Output Format Selection
When input signal exists, the output format LED turns on. If the input HDMI source is HDMI 1.3 format, you
can set the output format to HDMI 1.2 mode and Red LED will be on. If the input HDMI source is HDMI 1.2, the
output format is always set to HDMI 1.2.
1 If the HDTV shows video but without audio, please try to set audio mode to stereo
2 Factory default: Pin#1-OFF[
], Pin#2- OFF[
] for 1080p with stereo.
3 If you encounter any unsolved audio/video output problem during system installation, please
turn to Safe Mode (Pin#1- -
output for system check.
4 Bypass means the matrix will maintain playing the original format of HDMI signals in video
and perhaps audio. By setting at this mode, the users may encounter compatibility issue among
different kinds of HDMI sources and displays. If you cannot get the audio and/or video output
normally at the system installation, please change the DIP switch setting to default mode or even
safe mode to verify the functionality of the device.
20 seconds. The EDID learning procedure will be finished. If you want to learn the EDID from
another HDTV, you must set Pin#1 at OFF first and repeat this procedure.