Avital 5303 Universal Remote User Manual


 
21
© 2008 Directed Electronics—All rights reserved
Valet take-over
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle
for short periods of time, but would like to leave the motor
running and the climate controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release twice
within 3 seconds on the transmitter (or press and release the
optional momentary switch). Then wait five seconds.
2. Turn the ignition key to the OFF position. (The engine will
stay running.)
3. The engine will run until the pre-programmed time elapses
or a shut-down input is received. (See the previous Remote
Start section for a complete list of shut-down inputs.)
Note: This feature will not work if the brake pedal is
being pressed.
Note: If the temperature is greater than 55° F at the time
of remote start activation, the rear defogger will not acti-
vate for that start.
Note: If the remote start is on the lights will turn off then
flash 3-times before returning to their normal output and
the defogger output will activate as programmed.
G5303_2008-06H.qxd 7/9/2008 10:37 AM Page 21