Filter
Top Products
Chapter 3: Install the Industrial SFP/SFP Multi-Power Mode Converter
Page 8 724-746-5500 | blackbox.com LGC300A-R2
3. Install the Industrial SFP/SFP Multi-Power Mode Converter
The Industrial SFP/SFP Multi-Power Mode Converter installs anywhere as a
standalone, table-top device or on a DIN rail.
As a standalone device, install it in locations with limited space.
If multiple connections are required, use an IE-PowerTray/18 enclosure (sold
separately). The tray allows for 18 conversions in a 1.5 rack unit of space.
The units can also be powered by daisy-chaining DC power (refer to
Cascading DC Power).
3.1 SFP Port Requirements
The Industrial SFP/SFP Multi-Power Mode Converter requires two SFP
Modules of the same speed, either two Fast Ethernet (100Mbps) modules or
two Gigabit Ethernet (1000Mbps) modules.
3.2 DIN Rail Mounting
The Industrial SFP/SFP Multi-Power Mode
Converter includes two DIN clips, allowing
installation on a DIN rail. It mounts
perpendicular to the DIN rail (as shown).
Use the supplied screws to attach the DIN
clips to the Industrial SFP/SFP, and then
snap the converter to the DIN rail.
To remove the converter from the DIN rail,
use a flat-head screwdriver in the slot to
gently pry the converter from the rail.
NOTE
The DIN clips are designed for use on a DIN-35 rail.
3.3 Powering the Industrial SFP/SFP Multi-Power Mode Converter
The Industrial SFP/SFP Multi-Power Mode Converter requires an external
DC power source and has three options for powering as options:
• Universal AC power adapter with country specific clip (not included with
module version).