Filter
Top Products
8
Using the remote control
6 720 606 990
while turning on the power switch (I).
Release program key when LCD
displays “188”.
LCD shows “P2”. If not, repeat
previous step.
B Select “P3” using buttons and
on heater.
B Press and hold Program key
or again for 1 sec.
LCD shows one number and one
rotating digit. If not, repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number “0”, the second with
number “1” and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
double check the wire connections
made in section 4.2.
B Hold remote control in front of the
control panel on the heater and
press simultaneously remote control
buttons and until the
temperature indication is shown on
the remote control LCD.
B Switch power switch on the
appliance to the "OFF" (0) position
and then back "ON" (I).
B Press buttons or in order
to reach requested temperature.
New remote control is programmed.
4.3.2 SU board
B Connect power to heater.
B Move the main switch on the
appliance to the "OFF" (0) position.
B Press and hold key while at the
same time turning the main switch to
“ON” position (I).
LCD shows one number and one
rotating digit. If not repeat previous
step.
The number represents the remote
control which is to be registered, the
first remote control will be registered
with number “0”, the second with
number “1” and so on.
The rotating digit shows that the
electronics is expecting a registration.
If the LCD fails to show a number and
rotating digit after repeated attempts,
double check the wire connections
made in section 4.2.
B Hold remote control in front of the
control panel on the heater and
press simultaneously remote control
buttons or until the
6720606990-0701_(Remote control).fm Page 8 Tuesday, January 30, 2007 10:07 AM