Filter
Top Products
7
Remote control installation
6 720 606 990
Fig. 4 Support correct position
B Use the supplied cable to connect
between the main PCB and the
remote control PCB as shown in Fig.
5.
Fig. 5
B Replace the control unit cover with
the 4 Philips head screws (Fig. 3,
pos. 1).
B Slide control unit back into heater.
B Plug 2 yellow electrode wires from
the top of the control unit back onto
the ignition electrodes. Ensure all
connections are secure and tight
(Fig. 2, pos. 3).
B Pull end of power cord to take up
excess slack and tighten retaining
nut on the bottom of the heater.
B Reinstall the two electrical strip
connectors onto the PCB. The
larger connector connects to the
lower connection on the PCB.
Reseat the rubber seals for both
connectors.
B Replace the control unit auxiliary
cover. (Fig. 2, pos. 4).
B Replace front retaining bar using 5
Phillips head screws. (Fig. 2, pos 1).
i
Wire polarity does not
matter on the electrode
wires.
6720606990-0701_(Remote control)16Nov.fm Page 7 Friday, November 16, 2007 3:04 PM