Filter
Top Products
54
REFERENCE
REFERENCE
EnglishFrançais Español
Using the media center:
1. Lift the media center door and press the All Off button.
2. Press and hold the Enter button. Your current house code will appear in the media cen-
ter display window in the form of four rectangles, which represent the positions of
switches 1 through 4:
3. While holding the Enter button, press any button on the remote control.
The media center displays the new house code, which confirms its recognition of the
new code:
4. Release the Enter button. The system remains off.
5. If you have additional remote controls, change the switches to match those of the first
remote control by following steps 1-3 above. You do not need to repeat steps 4-5.
Note: To verify your system’s house code, press Enter while the system is off. The display
confirms the settings of switches 1-4.
Figure 26
Miniature switches on the
Primary remote are set for
use in the Main room (A)
Protecting and caring for your system
Follow the guidelines below when cleaning the surfaces.
• Do not use any solvents, chemicals, or cleaning solutions containing alcohol, ammonia,
or abrasives.
• Do not use any sprays near the system.
Cleaning the media center
Use only a soft, dry cloth to clean the outside of the media center.
HOUSE CODE:
Switches 1 - 4 down = 0 0 0 0 (current house code)
NEW HOUSE CODE:
(Switch 1 up, 2 down, 3 up, and 4 down = 1 0 1 0 (new house code)
123456789
123456789
Switches (1-4)
as set at the factory:
all switches down.
Switches 1-4 need to match those
switch settings in your main remote.
Set switches 5-9 for the room where
you will use the Bose
®
link remote.
Switch 5 determines which “audio
stream” (of two) you hear.
For more information on streams,
refer to “Setting up a second room
with sound” on page 55.
Switches 6-9 represent the room
where the remote will be used.
In the main room, the primary
remote is set as Room A with all
switches down.
Other switches
For a Bose
®
link remote
in another room