Filter
Top Products
3
INSTALLATION
Model RM325H Single-Wheel Blower
ROUGH-IN PLATE
MOUNTING
STUDS
MOUNTING
STUDS
BARREL
NUTS
WING
NUT
ROUGH-IN PLATE POWER CORD
(Locate at right side of hood)
BLOWER
POWER CORD
1. Mount rough-in plate to mounting studs on inside, top of hood. Use hex nuts
provided. Make sure power cord is at right side of hood.
2. Loosen barrel nuts and wing nut half-way.
3. Lift blower to rough-in plate and over barrel nuts. Slide blower sideward to
engage barrel nuts with small end of keyholes and wing nut with slot.
4. Tighten nuts to secure blower to rough-in plate.
5. Plug rough-in plate power cord and blower power cord into receptacles inside of
hood. DO NOT PLUG POWER CORDS TOGETHER.
VERTICAL DISCHARGE
COVER PLATE
MOUNTING
STUDS
MOUNTING
STUDS
BARREL
NUTS
WING NUT
BLOWER
POWER CORD
1. Remove cover plate from inside, back of hood and mount it to inside, top of
hood with same hardware. Make sure power cord is at right side of hood.
2. Mount rough-in plate to mounting studs on inside, back of hood. Use hex nuts
provided.
3. Loosen barrel nuts and wing nut half-way.
4. Lift blower to rough-in plate and over barrel nuts. Slide blower sideward to
engage barrel nuts with small end of keyholes and wing nut with slot.
5. Tighten nuts to secure blower to rough-in plate.
6. Plug rough-in plate power cord and blower power cord into receptacles inside of
hood. DO NOT PLUG POWER CORDS TOGETHER.
HORIZONTAL DISCHARGE
ROUGH-IN
PLATE
INSTALLATION
Model RM326H Dual-Wheel Blower
VERTICAL DISCHARGE
ROUGH-IN PLATE
MOUNTING
STUDS
MOUNTING
STUDS
BARREL NUT
BLOWER
POWER
CORD
1. Mount rough-in plate to mounting studs on inside, top of hood. Use hex nuts
provided. Make sure power cord is at right side of hood.
2. Loosen barrel nut half-way.
3. Lift blower to rough-in plate. Slide blower back to engage blower tab with slot in
rough-in plate and slot in blower with barrel nut.
4. Tighten barrel nut to secure blower to rough-in plate.
5. Plug rough-in plate power cord and blower power cord into receptacles inside of
hood. DO NOT PLUG POWER CORDS TOGETHER.
SLOT
BLOWER
TAB
HORIZONTAL DISCHARGE
COVER PLATE
MOUNTING
STUDS
MOUNTING
STUDS
BARREL NUT
BLOWER
POWER
CORD
SLOT
TAB
(at bottom-back
of blower)
1. Remove cover plate from inside, back of hood and mount it to inside, top of
hood with same hardware. Make sure power cord is at right side of hood.
2. Mount rough-in plate to mounting studs on inside, back of hood. Use hex nuts
provided.
3. Loosen barrel nut half-way.
4. Lift blower to rough-in plate. Slide blower down to engage blower tab with slot
in rough-in plate and slot in blower with barrel nut.
5. Tighten barrel nut to secure blower to rough-in plate.
6. Plug rough-in plate power cord and blower power cord into receptacles inside of
hood. DO NOT PLUG POWER CORDS TOGETHER.
ROUGH-IN PLATE POWER CORD
(Locate at right side of hood)
ROUGH-IN PLATE POWER CORD
(Locate at right side of hood)
ROUGH-IN PLATE
POWER CORD
(Locate at
right side
of hood)