Cambridge Audio DVD player DVD Player User Manual


 
9
DVD89
Speaker setup page continued
• Press the UP/DOWN ARROW buttons to select the first speaker to
configure.
• Measure the distance (in inches) from that speaker to the listening
position. If it is LESS than the distance to the Front Left speaker, enter
the difference (as close as possible) in inches using the LEFT/RIGHT
ARROW buttons. If it is GREATER than the distance to the Front Left
speaker, then leave the value at 0.
• Repeat for each speaker in the system (Center, Left Surround, Right
Surround, and Subwoofer) as available.
• Press the SELECT button to confirm the settings and return to the
Speaker Setup Page.
• If the distance between the listener and the front speakers are 60
inches, and the distance between the listener and the left surround
speaker is 80 inches, the distance difference is 20 inches.
• This DVD player does not support delays for when the distance
between the center or surround speakers and the listener are shorter
than that between the front speakers and the listener.
• In case the channel delay settings cannot match your speaker
configuration, please set all distance difference to 0 inch and use
your receiver/amplifier to set the channel delay (if possible).
7. Channel Trim: To set the volume of each individual channel.
• Press the LEFT/RIGHT ARROW buttons to select the channel to be
adjusted.
• Press the UP/DOWN ARROW buttons to raise or lower the volume of
the selected channel in 0.5dB increments.
• Press the SELECT button to confirm the settings and return to the
Speaker Setup Page.
Example channel delay adjustment:
Supported configuration
Settings:
Center Speaker – 4 Inches
Subwoofer – 4 Inches
Left Surround – 12 Inches
Right Surround – 12 Inches
Unsupported configuration
Settings:
Center Speaker – 0 Inch
Subwoofer – 0 Inch
Left Surround – 0 Inch
Right Surround – 0 Inch
ENGLISH