Filter
Top Products
10
The valet switch allows you to temporarily bypass all alarm functions eliminating the need to hand
your transmitter to parking attendants or garage mechanics. When the system is in Valet Mode, all
alarm functions and remote start functions are bypassed. However, the remote panic feature and
remote door locks remain operational. To use the Valet Mode, the system must first be disarmed
either by using your remote transmitter, or by operating the manual override sequence.
Valet Mode (System in Disarm or Valet Mode)
Enter Valet Mode
1. In the Disarmed Mode, turn the ignition to “ON”
position.
2.Push and hold the valet switch for 2 seconds
until the LED turns on solid. The LED will remain
on solid as long as the unit is in the Valet Mode.
Exit Valet Mode
1. To return to normal operation, turn “ON” ignition.
2. Push and hold valet switch for 2 seconds. The LED will turn off, indicating the system has now
exited the Valet Mode.
Remote Door Lock Remote Door Unlock
While in the Armed Mode, press the button to activate car locator function. The siren/horn will
chirp 6 times and the parking lights will flash 12 times to help you locate your car.
Car Locator
The transmitter can be used as a remote panic switch to manually trigger the alarm system in
case of an emergency.
1. Press and hold the button for 3 seconds to enter the Panic Mode (horn/siren will start to
sound and parking lights will flash).
2. While in Panic Mode the transmitter and buttons can be used to lock and unlock the door
(if that option is installed). However, if the button is pressed, the vehicle’s starter disable
device (when installed) will be disabled, allowing the vehicle to start.
3. To turn off the panic function, press and hold the or button again for 3 seconds.
Note: If any transmitter buttons other than or button is pressed the panic function will be
turned off.
4. If the panic function is not turned off by the transmitter, it will turn off and reset itself after 30
seconds.
Panic Function
PLUS-6850-UM 12/27/06 9:07 Page 10