Filter
Top Products
4. Operating Instructions 11 12/28/2009 12:38 PM
4. OPERATING INSTRUCTIONS
Using the control panel
Press <MODE> to switch between transmit and receive
mode; this will also enable the frequency assignment.
Press <DOWN/UP> to scroll through the operating
frequencies.
Press <ENTER> to save the settings.
Menu Option
Description
Receive mode: Sets the Satellite™ D-Fi/D-Fi™ PLUS to receive from a
transmitting D-Fi™ PLUS operating on the same frequency
Transmit mode: Sets the Satellite™ D-Fi/D-Fi™ PLUS to transmit to a
receiving Satellite™ D-Fi/D-Fi™ PLUS operating on the same frequency
Operating frequency: from to
A system is one Satellite™ D-Fi/D-Fi™ PLUS transmitting and one or more Satellite™ D-Fi/D-Fi™ PLUS
units receiving on the same frequency.
A minimum of 2 Satellite™ D-Fi/D-Fi™ PLUS units are required for operation.
Mode Selection
Each Satellite™ D-Fi may be used as a transmitter or a receiver, and is thereby referred to as a transceiver. In
order to the appropriate mode, please see the following steps.
1. Press <MODE>. The first group of segments on the LED display will begin blinking rapidly.
2. Press <MODE> again to change between (receive) and (transmit).
3. Press <ENTER>.
Frequency Selection
An operable system requires one transmitter and at least one receiver to be used on the same frequency.
Please see the steps below for instructions on how to set the frequency.
1. Press <MODE>. The first group of segments on the LED display will begin blinking rapidly.
2. Use <UP> and <DOWN> to select the frequency
3. Press <ENTER>.