Filter
Top Products
Installation Instructions iCMPFM1S/iCMPFM1B
11
INSTALL WALL PLATE TO WALL
WARNING: Failure to provide adequate structural
strength for this component can result in serious
personal injury or damage to equipment! It is the
installer’s responsibility to make sure the structure to
which this component is attached can support five
times the combined weight of all equipment.
Reinforce the structure as required before installing
the component.
1. Level wall plate (C) and mark locations of pilot
holes.
2. Drill 7/32" (5.5mm) diameter pilot holes into
wood studs.
3. Using 1/2" (12.7mm) wrench, install screws (Y)
through flat washers (Z), wall plate (C), into
wood studs.
4. Open both display latches.
3
1
1
X4
2
X4
(Y, Z) X4
4
X2
1/2" (12.7mm)
7/32" (5.5mm)
C
C