Filter
Top Products
12
Cisco Aironet Four-Port Dual-Band Polarization-Diverse Antenna (AIR-ANT2513P4M-N)
78-21447-01
Installing the Antenna
Figure 6 Assembling the Bracket Hardware
Step 5
Make sure you orient the antenna correctly (note the arrow on the back of the antenna that indicates the
top of the antenna). Use a 1/2 in. (13-mm) wrench to loosen the elevation adjustment bolt and the
elevation pivot bolt.
Step 6 Adjust the azimuth (side-to-side position) and elevation (up-and-down position) of the antenna. Loosen
the adjustment bolts slightly to allow for adjustment. Azimuth angle can be adjusted ±25 degrees and
elevation can be adjusted ±60 degrees. You can use the azimuth and elevation markings on the mounting
arm and the wall flange as a guide.
Step 7 After you adjust the antenna position, tighten the adjustment bolts and the pivot bolts. Tighten all bolts
to 18.7 +/- 5 lb-ft (25.4 Nm).
Step 8 Connect the antenna cables to the access point. The antenna ports are labeled A through D, from left to
right.
–
On the AP3702P, connect the antenna port A to connector A on the access point, antenna port
B to connector B, and so on.
–
On the AP1570, connect antenna port A to Port 1 on the AP, antenna port B to port 2 on the AP,
and so on.