Filter
Top Products
11
Cisco Aironet 5-GHz 14-dBi Directional Antenna (AIR-ANT5114P2M-N)
78-20958-01
Installing the Antenna
Installing the Optional Mounting Bracket Kit
Using an optional antenna mounting bracket kit, the AIR-ANT5114P2M-N antenna can be mounted
directly on an access point in a strand mount or pole mount environment. The antenna bracket kit
contains four bracket sections and fasteners that you can assemble in multiple configurations to position
and aim the directional antenna in a range of positions. For more information on mounting the antenna
with the optional mounting bracket, refer to Installing Antenna Brackets on Cisco 1550 Series Outdoor
Mesh Access Points.
Mounting on a Vertical Surface
The antenna can be wall mounted. Hardware is not included for wall-mount installation.
Follow these steps to mount your antenna on a vertical surface.
Step 1 Remove antenna and mount kit from packaging.
Step 2 Attach antenna mount bracket to the back of the antenna as shown in Figure 1, applying a maximum
nut-tightening torque of 55 in-lbf (6.2 Nm).
Step 3 Attach elevation adjustable bracket (B) as shown in Figure 2 and loosely secure hardware. The carriage
bolt square holes must be on the inside.
Step 4 Using the appropriate customer-supplied anchors and screws, attach the azimuth adjustable bracket to
the wall as shown:
Figure 6 Wall Mounting
Figure 7 shows, in inches, the distance between the bracket mounting holes.
334653